Replacing a Washing Machine Dispenser Hose

By Mike attempts | Aug 28, 2019
RSS
A few months after replacing the boot seal on my Whirlpool Duet washer ( https://youtu.be/hykbo06zigw ), I noticed a small leak during the rinse cycle but only while washing large loads of laundry. I eventually figured out that large loads would cause the water to slosh higher up the side of the tub, seep out the hole that the dispenser hose attaches to, run down the outside of the tub, and drip in the bottom of the washer. See the links below for the parts and tools I used:

Dispenser Hose (W11366227):
https://amzn.to/3dJ3S3z (affiliate*)

Milwaukee Drill & Driver:
https://amzn.to/2UNNUMZ (affiliate*)

Milwaukee Stick Light:
https://amzn.to/33WCACm (affiliate*)

*Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!