Repairing a Plasma Cutter

By Mike attempts | Jun 17, 2020
RSS
Repairing a Miller Spectrum 300 CutMate plasma cutter with a Miller ICE-25C torch. This plasma cutter had no air flow and no arc. See the links below for the parts and tools I used:

Swirl Ring:
https://amzn.to/2BSHndX (affiliate*)

Consumables:
https://amzn.to/30BNNst (affiliate*)

Bench Grinder:
https://amzn.to/3bcTDCW (affiliate*)

Wire Wheel:
https://amzn.to/3a65Zve (affiliate*)

Wire Strippers:
https://amzn.to/2BPldt2 (affiliate*)

*Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!